Bearing off: why a 3 cannot take a checker off the 2-point
Published · By TG, the site operator
Bearing off is the last stage of the game, and the rule that surprises most new players is about which checker a die may remove. The U.S. Backgammon Federation says a player must have all active checkers in the home board before bearing off, and that a checker is removed by a roll that matches its point. This note checks what happens when the checkers are not all on one point, using the move code this site runs.
The position
Take a White position with twelve checkers on the 1-point, two on the 4-point and one on the 2-point. All fifteen are home, so bearing off is allowed. The 4-point is the highest point that still holds a checker.
What each die can do
- 6 or 5: the checker on the 4-point bears off. Both dice are bigger than the distance to the edge, and no checker stands on a higher point, so the big die may take the highest checker.
- 4: the 4-point checker bears off exactly.
- 3: no checker bears off. The only legal play moves one checker from the 4-point to the 1-point.
- 2: the 2-point checker bears off, or a checker moves from the 4-point to the 2-point.
- 1: the 1-point checker bears off, or a checker moves down from the 2-point or the 4-point.
The 3 is the interesting case. A 3 is larger than the 2-point checker needs, but it cannot take that checker off while a checker stands on the 4-point. The rule is that a die larger than a checker's distance may bear that checker off only when no checker is on a higher point. Clear the 4-point, and the same 3 bears off from the 2-point. The script shows this for every die from 2 to 6.
Why the highest point goes first
The rule keeps the high checkers from being left behind. If a 6 could take a low checker while a checker still sat on the 4-point, the 4-point checker would need a later roll that might never come. Our move code applies the same rule to both sides of the board, so what you see on the table is what the rule says.
Home board first
A checker outside the home board blocks all bearing off, even when a roll would normally take a checker off. Move the 2-point checker to the 7-point, leaving twelve on the 1-point and two on the 4-point. Now a 6 moves that checker to the 1-point, and a 5 moves it to the 2-point. Neither bears off. The rule in our guide says the same thing: you may bear a checker off only when every checker you still have is in your home board.
Practise it on our table
You cannot set up these positions on the board, but bearing-off choices come up in every game against the computer once all fifteen checkers are home. Select a checker and the board shows the moves that are legal for your roll. The Bear off button is available only when the rule allows a checker to come off, and The race home panel shows the borne-off count for each side. Start a game at Easy, Normal or Hard and watch when the Bear off button becomes available.
Sources
- Backgammon Basics: How To Play (Bearing Off section) — U.S. Backgammon Federation
- Guide: Bearing off waits until the home board is full of your own checkers — This site
Written by the operator of this site from the sources listed above. Spotted a mistake? Email warmeve.label@gmail.com and it will be corrected.